Pipeline steel edge water stop construction site
The steel edge sealing tape is a new type of rubber sealing tape which is used for inserting hot-dip galvanized steel tape into the vulcanized rubber. It is suitable for many large-scale construction fields, especially when the water pressure is high and the structural deformation is large. More obvious. The use of ordinary rubber water stop, when the structural deformation is large, the rubber water stop with the settlement of the structure, its transverse section elongated, thin, exceeds its fatigue deformation limit, it is likely to form a new leak gap .
When steel-edge rubber waterstops are used, the steel edges on both sides are strongly bonded to the surrounding concrete structures, and the steel edges and the rubber edges are the same as the steel edges and the rubber is extremely strong. When the structure is deformed, only the rubber part is elongated and thin, and no new leakage gap occurs between the steel edge and the concrete and between the steel edge and the rubber. Therefore, when the steel structure is deformed by the steel-edge rubber waterstop, The anti-seepage performance at the same time has played an important quality guarantee for the whole project of seepage and sealing.
The fully-deformed seam of the buried steel-edge rubber waterstop is a new type of deformation joint pattern developed in the form of semi-complete seams such as post-casting belts. The steel edge neoprene waterstop tape is completely deformed to prevent cracks. , anti-leakage, anti-dislocation, anti-aging and other aspects of the semi-complete seam compared to a large degree of improvement.
The principle of the rubber-side water-stopping rubber belt: The water-stopping belt starts or stops the water in the deformation joint or the joint of the large-scale water storage tank. During the construction, the cooperation of clamping and positioning steel bars of the template ensures that the steel edge neoprene rubber water stop is in the designed position. The neoprene rubber waterstop in the bottom plate and the steel wall in the pool wall should be connected into a whole. The rivets are used to connect the plates at the joints, and the rubber is connected by hot melt.
The blocks separated by steel-edge rubber waterstops during construction must be staggered. If block A is to be constructed first, block B adjacent to it must be formed after the concrete of block A is formed. After the entire molding, the water inside and outside the pool is blocked by the steel edge neoprene water stop tape, and the steel sheet is added to the two rubber wings to enhance the anti-deformation ability, thereby improving the waterproof capacity after deformation.
Monitor Stand For Computer Screens
Shenzhen ChengRong Technology Co.,Ltd. , https://www.dglaptopstandsupplier.com