Many friends have heard about the method of short-circuiting and saving bricks, but they have been afraid to try. They fear that because of a short circuit burning the box, the landlord will now teach you how to use the short-circuit method to save the bricks.
Tip: short circuit with the metal object as shown in the FLASH 5,6 pin, and then power on the box 3-5 seconds, in the short-circuited metal objects away, when the robot appears to enter the save brick mode.
2. The system automatically reads and enters the SD card for recovery mode. See the figure below and restart the brushing machine.
After successfully saving the brick, you can continue to brush any firmware above UI2.3 and upgrade it offline.
Tips: If you see the (small green man) fall down to read the card content failed (look at the metal part of the SD card will not contact badly), or re-produce the startup card (remember to put three files in), check Whether the SD is inserted into the position, etc. (If necessary, insert it tightly and pull it gently outwards).
Special Note: Must be optimistic about which of the two short pins, the picture has been marked, do not short the error! Otherwise, only the factory is returned! ! !
Brush address: http://bbs.shafa.com/thread-1293484-1-1.html
High Frequency Ferrite Transformer,Electric Transformer,Core Type Transformer,Frequency Transformer,coilcraft transformer,electrical transformer
IHUA INDUSTRIES CO.,LTD. , https://www.ihuagroup.com